Since yesterday I'm testing USB pen drives connected to J3 connector of DK-S7G2.
I found two suitable application notes
an-r11an0173eu0101-synergy-ux-host-class-mass-storage-mod-guide.zip
and
an-r30an0239eu0122-synergy-usbx-MassStorageClass-host.zip
but when I use them neither work: no success LED is activated and the file counter.txt is not created, nor updated, over the pen drive.
I must point out that the DK-S7G2 workspace were imported and then automatically updated during the Generate Project Content and Build actions, in fact the development PC I'm using has only e2studio 6.2.0 and SSP 1.3.0 and 1.4.0.
I confirmed the irreversible update proposal and everything happened without problems, I suppose.
After hours of investigation I saw that the program starts but it does not generate any USB Host event.
I searched my self possible reason why and I read many posts dedicated to USBX Mass Storage Class Host but but I didn't found a solution and in a few hours I should finish the test!
Are there up dated workspace, already tested and ready to use?
Any suggestion will be really appreciated.
Best regards
MPGA