Hallo,
I'm still not able to get an UART-console running!
Listed below all the things I've done in the past, to get the UART console running:
1. PIN 12 U7 tied to 3,3V (S7G2 SK)
2. Upgarde: e2studio to 5.0.0.48 and SSP to 1.1.0 alpha
3. UART framework interface is working without problem (Tx and Rx - transmitting a text string, after receiving a specifc char)
4. USB and Etherent console are also working without problems
5. UART console has a strange behavior: e.g. sending "?" response "?" instead of console menue
If 1...4 is working, so I guess it should be possible (also for me) to get an UART console working, as well.
Either there is a wrong setting in my g_uart (r_sci_uart), what I can't figure out or something is wrong in the UART console framework (from my point of view), because the UART framework behaves correctly.
As I mentioned in my former posts, an UART console sample from the Synergy Team would be very appreciated!
Thank you!
Regards
Ralph