Hi all,
I'm currently trying to control a stepper motor using the stepper motor controler PCA9629 from NXP, using the I2C comunnication.
My problem is that after the motor finishes it's cycle or after a while the microcontroler is reset.
The only connections that i have on the microcontroler is the SDA,SCL, VCC and GND.
Does anyone have any idea how it's possible that the microcontroler is reset after a while and also is there a way
to access any register that will provide me a information about the reason why the microcontroler is reset ?
Regards,
Phillipe