Sk s7g2 Low power mode

Hello ,

I've been running the Low Power Modes V2 application example for S7G2 on the SK s7g2 board.

I've remove the R113 resistor and I power up the MCU through the J31 Jumper.

When I measure the current in Deep software standby mode I get 3.6 mA instead of 37µA from the datasheet. I've set the setting to let the MCU go to deep software standby mode in e2studio.

I've looked at the schematic and I don't see what's could draw this current. 

Did I miss something ? What results do you have on your board?

Regards,

TK