Hello.
I am testing with SK-S7G2 Starter Kit. I run Flash application note HAL Module Guide - Application Project downloaded from the Renesas Home website -> Software and Tools -> Boards and Kits. I have tested with SSP1.3.0 and SSP1.3.2. The problem is the following.
I execute the complete application and in the memory it remains as shown in the IMAGE 1. I put power off to SK-S7G2, after, put power on, and before the application is executed and erase the flash memory, I look at the value that is in the memory and each time I do it, there are different values, as shown in the IMAGE 2.
There should be the same data that was before removing the power to the board.
Can someone help me find out where the problem is?
IMAGE 1
IMAGE 2
Best regard.