We are using the external bus but only Address pins A00 - A05. We configured System:BUS for custom bus using CS0 and the P602 pin enabled as BCLK. We are not seeing the BCLK output on a scope. Looking thru the hardware manual, I found reference to register EBCKOCR with bit EBCKOEN as the enable bit for EBCLK output. This bit is at 0 in the emulator and trying to set it to 1 fails. I found other references to PmnPFS:PSel bits needing to be in a certain state. Am I missing some setup or should SSP be doing all this configuration?
↧