Hello All,
I have been trying to get the USB CDC up and running in one of the custom Boards designed with Synergy S1 (48-pin) MCU.
Without any luck, Initially, i did not find any Example Program for the Port Then after going through the forum I found the below link as a reference...
http://renesasrulz.com/synergy/f/synergy---forum/7745/dk-s124-usbx-example
Even following the same steps as mentioned in the post I am unable to replicate and get the USB running...
But with the Same logic of the console Framework, I am able to get the CDC class running on the S7 MCU... (I have tried SPP1.1.3 and 1.2.1 beta)
Kindly advice if there are any checks that can be done to check that the USB Hardware is proper. or any changes required for the Framework I have cross checked with the Synergy DK-S124 board schematic with our board and both match up....
Any support with this regard will be of great help...
With Regards,
Nikhil Ullal